Telit Wireless Solutions WE866E4-P - Start NMDNS Module

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 128 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 277, page 128, describes the synchronous responses and remarks for NMDNS
Service De-registration command.
10.1.2.6 Start NMDNS Module
This command is used to start mDNS module. Before issuing this command is required to
issue L2 and L3 commands.
Command Syntax AT+NMDNSSTART
Response
Table 278, page 128, describes the responses and remarks for Start NMDNS Module
command.
Synchronous Response
Table 279, page 129, describes the synchronous responses and remarks for Start NMDNS
Module command.
Table 276 NMDNS Service De-registration Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 277 NMDNS Service De-registration Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 278 Start NMDNS Module Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.