Telit Wireless Solutions WE866E4-P - Wireless Network Connection Management; AP Configuration

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 52 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 83, page 52, describes the synchronous responses and remarks for Disassociation
command.
7.2 Wireless Network Connection Management
7.2.1 AP Configuration
This command is used to set the configuration values to create a Network. Prior to issuing
this command, user is required to create a netork by issuing AT+WNCR command (if the
command is not used, then the default values is used)
Command Syntax AT+WNAPC=<WHANDLE>,<HIDDEN SSID>,<Beacon Interval>,<DTIM Period>
Parameter Description
Table 84, page 52, describes the AP Configuration parameters.
Table 83 Disassociation Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 84 AP Configuration Parameters
Parameters Mandatory/Optional Value Description
WHANDLE Mandatory
Value range: 0,1
Format: Integer
Default value: 1
It specifies the return value from AT+WNI
command.