WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 61 2018-02-16
PRELIMINAR
Y
7.2.8 Create Network
This command is used to create a Network. Prior to issuing this command, the user is
required to issue the initialize NCM command.
Command Syntax AT+WNCR=<WHANDLE>,<SSID>,<Channel>,<Security Type>,<Encryption
Time>,[<Passphrase>]
Parameter Description
Table 103, page 61, describes the Create parameters.
Table 102 Connection Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 103 Create Network Parameters
Parameters Mandatory/Optional Value Description
WHANDLE Mandatory
Value range: 0,1
Format: Integer
Default value: 0
It specifies the return value from
AT+WNI=1 command.
The user is required to be in AP mode
while issuing this command.
SSID Mandatory
Value range: 1-32
Format: String
Default value:
Telit_Guest
It specifies the SSID that has to be
connected.
The user required to provide the SSID of
the AP to be connected.
Channel Mandatory
Value range:
1-14,36,40,44,48,5
2,56,60,64,100,104
,108,112,116,132,1
36,140,149,153,15
7,161,165
Format: Integer
Default value: 6
Unit: N/A
It specifies the channel of an AP to
connect.
If channel is not mentioned then the
command scans all the channel to find an
AP to connect.
To Next Page
Loading...