Telit Wireless Solutions WE866E4-P - Verbose Mode

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 39 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 50, page 39, describes the synchronous responses and remarks for Data Mode
command.
6.4.12 Verbose Mode
This command is used to enable or disable Verbose mode.
Command Syntax ATVn
Parameter Description
Table 51, page 39, describes the Verbose Mode parameters.
Response
Table 52, page 39, describes the responses and remarks for Verbose Mode command.
Table 49 Data Mode Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 50 Data Mode Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 51 Verbose Mode Parameters
Parameters Mandatory/Optional Value Description
n Mandatory
Value range: 0,1
Format: Integer
Default value: 1
It specifies the enable or disable of Echo
mode, where:
1- enables Verbose mode
0- disable Verbose mode.
Table 52 Verbose Mode Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.