Telit Wireless Solutions WE866E4-P - Application PCB Design Guidelines; Module Footprint

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 35 2018-02-16
PRELIMINAR
Y
6.4.7 Write File
This command is used to write the specified file from a given offset. Prior to issuing this
command, the file must be open.
Command Syntax AT+YFWR=<FIle Descriptor>,<Offset>,<Data>
Parameter Description
Table 37, page 35, describes the Write File parameters.
Response
Table 38, page 35, describes the responses and remarks for Write File command.
Table 37 Write File Parameters
Parameters Mandatory/Optional Value Description
File
Descriptor
Mandatory
Value range:
0X0-0XFFFFFFFF
Format: Hexa
Default value:
N/A
It specifies the value returned while
opening a file.
Offset Mandatory
Value range:
0-1024
Format: Integer
Default value:
N/A
It specifies offset from the starting of the
file.
Data Mandatory
Value range:
0-1024
Format: Integer
Default value:
N/A
It specifies the data to be written.
Table 38 Write File Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.