Telit Wireless Solutions WE866E4-P - Configure SSL

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 100 2018-02-16
PRELIMINAR
Y
Response
Table 204, page 100, describes the responses and remarks for SSL Close command.
Synchronous Response
Table 205, page 100, describes the synchronous responses and remarks for SSL Close
command.
9.3.1.7 Configure SSL
This command is used to configure the SSL connection. Prior to issuing this command, user
is required to establish L2 and L3 connection.
Command Syntax AT+NSSLCFG=<CID>,<Configuration ID>,<Configuration value>
Parameter Description
Table 206, page 101, describes the Configure SSL parameters.
Table 203 SSL Close Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the connection ID after
AT+NSSLINIT command.
Table 204 SSL Close Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 205 SSL Close Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.