Telit Wireless Solutions WE866E4-P - AP Statistics; Associated Station Information

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 58 2018-02-16
PRELIMINAR
Y
7.2.5 AP Statistics
This command is used to get the statistics of WLAN interface in AP mode. Prior to issuing
this command, the user is required to issue AT+WNCR command.
Command Syntax AT+WNAPST
Response
Table 96, page 58, describes the responses and remarks for AP Statistics command.
Synchronous Response
Table 97, page 58, describes the synchronous responses and remarks for AP Statistics
command.
7.2.6 Associated Station Information
This command is used to print the information of connected stations with the MAC address
and the IP address, when WLAN interface is in AP mode. Prior to issuing this command,
the user is required to initilize the NCM and set the IP configuration command.
Table 96 AP Statistics Response
Responses Remarks
+WNAPST:ucastTxPkts, ucastRxPkts, mcastTxPkts,
mcastRxPkts, bcastTxPkts, bcastRxPkts ucastNonNullTxPkts,
ucastNonNullRxPkts, ucastFilteredAcceptedTxPkts,
ucastFilteredAcceptedRxPkts, mcastFilteredAcceptedTxPkts,
mcastFilteredAcceptedRxPkts, bcastFilteredAcceptedTxPkts,
bcastFilteredAcceptedRxPkts, ucastFilteredRejectedTxPkts,
ucastFilteredRejectedRxPkts, mcastFilteredRejectedTxPkts,
mcastFilteredRejectedRxPkts, bcastFilteredRejectedTxPkts,
bcastFilteredRejectedRxPkts, nullTxPkts, nullRxPkts,
qosNullTxPkts, qosNullRxPkts, psPollTxPkts, psPollRxPkts,
txRetryCnt, beaconMissCnt, beaconsReceivedCnt,
beaconResyncSuccessCnt, beaconResyncFailureCnt,
currEarlyWakeupAdjInMs, avgEarlyWakeupAdjInMs,
earlyTerminationCnt, uapsdTriggerRxCnt, uapsdTriggerTxCnt,
totalActiveTimeInMs, totalPowersaveTimeInMs
Success.
ERROR Failure.
Table 97 AP Statistics Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.