Telit Wireless Solutions WE866E4-P - IP Configuration in AP Mode

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 55 2018-02-16
PRELIMINAR
Y
7.2.3 IP Configuration in AP mode
This command is used to set the IPv4 start address, IPv4 range and lease time for an Ap that
is required to create a Network. Prior to issuing this command, the user is required to issue
the initialize NCM command.
Command Syntax AT+WNAPIPC=<WHANDLE>,<IP Start Address>,<IP Range Address>,<Lease
Time>
Parameter Description
Table 90, page 55, describes the IP Configuration parameters.
Table 89 Get AP Configuration Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 90 IP Configuration Parameters
Parameters Mandatory/Optional Value Description
WHANDLE Mandatory
Value range: 0,1
Format: Integer
Default value: 0
It specifies the return value from
AT+WNI=1 command.
The user is required to be in AP mode
while issuing this command.
IP Start
Address
Mandatory
Value range: 7-32
Format: Integer
Default value:
0.0.0.0
It specifies the starting of the IPV4 address
allocated to connected stations when
connected to an AP.
IP Range
Address
Mandatory
Value range: 7-32
Format: Integer
Default value:
0.0.0.0
Unit: N/A
It specifies the maximum range an AP
allocates for stations connected to its
network.
Lease Time Mandatory
Value range:
1-4294967295
Format: Integer
Default value:
86400000
Unit: N/A
It specifies the lease time for DHCP
Server.