Telit Wireless Solutions WE866E4-P - Get MAC Address

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 50 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 77, page 50, describes the synchronous responses and remarks for Set MAC Address
command.
7.1.4 Get MAC Address
This command is used to get the MAC address of WLAN interface. Prior to issuing this
command the user required to initialize the WLAN interface.
Command Syntax AT+WMACG=<WHANDLE>
Parameter Description
Table 78, page 50, describes the Get MAC Address parameters.
Response
Table 79, page 50, describes the responses and remarks for Get MAC Address command.
Table 76 Set MAC Address Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 77 Set MAC Address Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 78 Get MAC Address Parameters
Parameters Mandatory/Optional Value Description
WHANDLE Mandatory
Value range: 0,1
Format: Integer
Default value: 1
It specifies the Device ID of the WLAN
interface, where
0- specifies disables WLAN interface
1- specifies enable the WLAN interface.
Table 79 Get MAC Address Response
Responses Remarks
OK Success.