Telit Wireless Solutions WE866E4-P - WNCM IP Configuration

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 66 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 115, page 66, describes the synchronous responses and remarks for Interface
Configuration command.
7.2.13 WNCM IP Configuration
This command is used to set the IPv4 start address, IPv4 range and lease time for an Ap that
is required to create a Network. Prior to issuing this command, the user is required to issue
the initialize NCM command.
Command Syntax AT+WNIPC=<WHANDLE>,<IP Flag>,[<IP Address>,<IP Mask>,<IP GAteway>]
Parameter Description
Table 116, page 66, describes the IP Configuration parameters.
Table 115 Interface Configuration Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 116 IP Configuration Parameters
Parameters Mandatory/Optional Value Description
WHANDLE Mandatory
Value range: 0,1
Format: Integer
Default value: 0
It specifies the return value from
AT+WNI=1 command.
The user is required to be in AP mode
while issuing this command.
IP Flag Mandatory
Value range: 0-3
Format: Integer
Default value: 1
It specifies the IP configuration is woyh
static or DHCP.