Telit Wireless Solutions WE866E4-P - Using SDK Builder; Serial-To-Wifi Module Information

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 18 2018-02-16
PRELIMINAR
Y
– Obtain IP Address and Start Data Transfer.
– Select advanced services if any.
4. Debug Host and GainSpan module
– Debug using provided AT commands and other options if required. (Refer
WE866E4-P AT Command Reference Guide)
– Analyze using Wire shark over wireless. For more details, refer information about
AirPcap Nx in http://www.riverbed.com
5. Production Process
– Perform generic recommendations in production line
– Perform RF tests
3.2 Using SDK Builder
3.2.1 Serial-to-WiFi Module Information
Selecting the Serial-to-WiFi (Hosted) under the SDK Builder Configuration screen
displays the module information that includes the module selected, firmware version.
NOTE: Refer “WE866E4-P Use Case Reference Guide document for detailed
use cases and examples