Telit Wireless Solutions WE866E4-P - SSL Connection

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 102 2018-02-16
PRELIMINAR
Y
9.3.1.8 SSL Connection
This command is used to connect to the SSL server. Prior to issuing this command, user is
required to establish L2 and L3 connection.
Command Syntax AT+NSSLCO=<CID>,<Server IP Address>,<Server port number>
Parameter Description
Table 209, page 102, describes the SSL Connection parameters.
Response
Table 210, page 102, describes the responses and remarks for SSL Connection command.
Synchronous Response
Table 211, page 102, describes the synchronous responses and remarks for SSL Connection
command.
Table 209 SSL Connection Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the connection ID after
AT+NSSLINIT command.
Server IP Address Mandatory
Value range:7-40
Format: Integer
Default value:
0.0.0.0
It specifies the IP address of the server to
connect.
Server port number Mandatory
Value
range:0-65535
Format: Integer
Default value: 0
It specifies port number of the SSL server.
Table 210 SSL Connection Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 211 SSL Connection Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.