Telit Wireless Solutions WE866E4-P - 10 Advanced Services; Network; Ping

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 122 2018-02-16
PRELIMINAR
Y
10 Advanced Services
This chapter describes the commands for configurations and operations related to advanced
services of Network and WE866E4-P supported Application features.
• Network, page 122
• Application Features, page 133
10.1 Network
10.1.1 Ping
This command is used to test the accessibility of the host on the Internet Protocol network.
Command Syntax AT+NPING=<IP Address>,[<Payload>,<Count>]
Parameter Description
Table 260, page 122, describes the Network Ping parameters.
Response
Table 261, page 123, describes the responses and remarks for Network Ping command.
Table 260 Network Ping Parameters
Parameters Mandatory/Optional Value Description
IP Address Mandatory
Value range:7-32
Format: N/A
Default value: 0
It specifies the IP address to ping.
Payload Optional
Value range:
1-1576
Format: Integer
Default value: 64
It specifies the payload of each packet size
to the ping.
Count Optional
Value range:
1-6535
Format: Integer
Default value: 1
It specifies the number of ping.