Telit Wireless Solutions WE866E4-P - Initialization

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 64 2018-02-16
PRELIMINAR
Y
Response
Table 109, page 64, describes the responses and remarks for Disconnect Network
command.
Synchronous Response
Table 110, page 64, describes the synchronous responses and remarks for Disconnect
Network command.
7.2.11 Initialization
This command is used to initialize NCM module based on the mode selected by the user.
Command Syntax AT+WNI=<Mode>
Parameter Description
Table 111, page 64, describes the Initialization parameters.
Response
Table 112, page 65, describes the responses and remarks for Initialization command.
Table 109 Disconnect Network Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 110 Disconnect network Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 111 Initialization Parameters
Parameters Mandatory/Optional Value Description
Mode Mandatory
Value range: 0,1
Format: Integer
Default value: 0
It specifies the start of the WLAN
interface, taking following values:
0- specifies the interface starts in station
mode and
1- specifies the interface starts in AP
mode.