Telit Wireless Solutions WE866E4-P - System Reset

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 42 2018-02-16
PRELIMINAR
Y
6.6 System Reset
This command is used to perform a soft reset to the module.
Command Syntax AT+YSR
Response
Table 56, page 42, describes the responses and remarks for System Reset command.
Synchronous Response
Table 57, page 42, describes the synchronous responses and remarks for System Reset
command.
Table 56 System Reset Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 57 System Reset Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.