Telit Wireless Solutions WE866E4-P - Auto Mode; Get Auto Mode

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 36 2018-02-16
PRELIMINAR
Y
6.4.8 Auto Mode
This command is used to enable or disable Auto mode.
Command Syntax ATCn
Parameter Description
Table 39, page 36, describes the Auto Mode parameters.
Response
Table 40, page 36, describes the responses and remarks for Auto Mode command.
Synchronous Response
Table 41, page 36, describes the synchronous responses and remarks for Auto Mode
command.
6.4.9 Get Auto Mode
This command is used to get the status of the Auto mode operation.
Command Syntax ATCn?
Parameter Description
Table 42, page 37, describes the Get Auto Mode parameters.
Table 39 Auto Mode Parameters
Parameters Mandatory/Optional Value Description
n Mandatory
Value range: 0,1
Format: Integer
Default value: 1
It specifies the Auto mode being enabled
or disabled.
1 - enables Auto mode
0- disables Auto mode.
Table 40 Auto Mode Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 41 Auto Mode Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.