Telit Wireless Solutions WE866E4-P - Get NDNS Client Server IP Address

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 76 2018-02-16
PRELIMINAR
Y
Table 140, page 76, describes the synchronous responses and remarks for Set NDNS Client
Server IP Address command.
8.2.7 Get NDNS Client Server IP Address
This command is used to set the IP server in DNS module. Before setting the server IP
address request, ID of the server IP address has to be set.
Command Syntax AT+NDNSCSRVIP?
Parameter Description
Table 141, page 76, describes the Get NDNS Client Server IP Address parameters.
Response
Table 142, page 76, describes the responses and remarks for Get NDNS Client Server IP
Address command.
Synchronous Response
Table 143, page 77, describes the synchronous responses and remarks for Get NDNS Client
Server IP Address command.
Table 140 Set NDNS Client Server IP Address Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 141 Get NDNS Client Server IP Address Parameters
Parameters Mandatory/Optional Value Description
Server IP
Address
Mandatory
Value range: N/A
Format: Decimal
Default
value:8.8.8.8
It specifies the IP address of the server.
Table 142 Get NDNS Client Server IP Address Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.