Telit Wireless Solutions WE866E4-P - Stop NMDNS Server

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 124 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 265, page 124, describes the synchronous responses and remarks for Start NMDNS
Server command.
10.1.2.2 Stop NMDNS Server
This command is used to stop the server in mDNS module. Before issuing this command
user is required to issue L2 and L3 and must have issued mDNS start command.
Command Syntax AT+NMDNSSSTOP
Parameter Description
Table 266, page 124, describes the Stop NMDNS Server parameters.
Response
Table 267, page 124, describes the responses and remarks for Stop NMDNS Server
command.
Table 264 Start NMDNS Server Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 265 Start NMDNS Server Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 266 Stop NMDNS Server Parameters
Parameters Mandatory/Optional Value Description
Stop Mandatory
Value range:N/A
Format: N/A
Default value:
N/A
It indicates the mDNS module to stop.
Table 267 Stop NMDNS Server Response
Responses Remarks
OK Success.