Telit Wireless Solutions WE866E4-P - NDNS Server Stop

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 73 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 131, page 73, describes the synchronous responses and remarks for Get NDNS
Server Stop command.
8.2.4 NDNS Server Stop
This command is used to indicate the stop the DNS server. Prior to starting the server the
user is required to issue L2 and L3, along with DNS server start command.
Command Syntax AT+NDNSSSTOP?
Parameter Description
Table 132, page 73, describes the NDNS Server Stop parameters.
Response
Table 133, page 73, describes the responses and remarks for NDNS Server Stop command.
Synchronous Response
Table 133, page 73, describes the synchronous responses and remarks for NDNS Server
Stop command.
Table 131 Get NDNS Server Stop Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 132 DNS Server Stop Parameters
Parameters Mandatory/Optional Value Description
Stop Mandatory
Value range:N/A
Format: N/A
Default value:
N/A
It indicates the server to stop.
Table 133 NDNS Server Stop Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.