Telit Wireless Solutions WE866E4-P - Moisture Sensitivity Handling

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 46 2018-02-16
PRELIMINAR
Y
6.7.4 Get SNTP Start
This command is used to get the status of SNTP start.
Command Syntax AT+NSNTPSTART?
Parameter Description
Table 66, page 46, describes the Get SNTP Start parameters.
Response
Table 67, page 46, describes the responses and remarks for Get SNTP Start command.
Synchronous Response
Table 68, page 46, describes the synchronous responses and remarks for Get SNTP Start
command.
Table 66 Get SNTP Start Configuration Parameters
Parameters Mandatory/Optional Value Description
Status Optional
Value range: N/A
Format: String
Default value:
N/A
It specifies the status of SNTP start
(STARTED or NOT STARTED).
Table 67 Get SNTP Start Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 68 Get SNTP Start Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.