WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 68 2018-02-16
PRELIMINAR
Y
Command Syntax AT+WNIPC?
Response
Table 119, page 68, describes the responses and remarks for Get WNCM IP Configuration
command.
Synchronous Response
Table 120, page 68, describes the synchronous responses and remarks for Get WNCM IP
Configuration command.
7.2.15 WLAN Interface Statistics
This command is used to get the WLAN interface statistics in AP mode. Prior to issuing
this command, the user is required to issue the connection command and be in Station
mode.
Command Syntax AT+WNSTAST
Response
Table 121, page 69, describes the responses and remarks for Interface Statistics command.
Table 119 GEt WNCM IP Configuration Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 120 Get WNCM IP Configuration Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
To Next Page
Loading...