Telit Wireless Solutions WE866E4-P - SSL Bind

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 98 2018-02-16
PRELIMINAR
Y
Command Syntax AT+NSSLA=<CID>
Parameter Description
Table 197, page 98, describes the SSL Certificate Accept parameters.
Response
Table 198, page 98, describes the responses and remarks for SSL Certificate Accept
command.
Synchronous Response
Table 199, page 98, describes the synchronous responses and remarks for SSL Certificate
Accept command.
9.3.1.5 SSL Bind
This command is used to bind the server port to a socket. Prior to issuing this command,
user is required to establish L2 and L3 connection.
Command Syntax AT+NSSLB=<CID>,[<Locale IP Address>],<Local port number>
Parameter Description
Table 200, page 99, describes the SSL Certificate Bind parameters.
Table 197 SSL Certificate Accept Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the connection ID after
AT+NSSLINIT command.
Table 198 SSL Certificate Accept Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 199 SSL Certificate Accept Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.