Telit Wireless Solutions WE866E4-P - Set NDNS Client Server IP Address

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 75 2018-02-16
PRELIMINAR
Y
8.2.6 Set NDNS Client Server IP Address
This command is used to set the IP server in DNS module. Before setting the server IP
address request, ID of the server IP address has to be set.
Command Syntax AT+NDNSCSRVIP=<IP address>, [<ID of the IP address>]
Parameter Description
Table 138, page 75, describes the Set NDNS Client Server IP Address parameters.
Response
Table 139, page 75, describes the responses and remarks for Set NDNS Client Server IP
Address command.
Synchronous Response
Table 137 NDNS Client Resolve URL Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 138 Set NDNS Client Server IP Address Parameters
Parameters Mandatory/Optional Value Description
IP Address Mandatory
Value range:1-32
Format: Decimal
Default
value:8.8.8.8
It specifies the server IP address to be set
ID Optional
Value range:
0x0,0x1,0xFFFF
Format: Hexa
Decimal
Default value:
FFFF
It specifies the ID of the server IP address
to be set.
Table 139 Set NDNS Client Server IP Address Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.