Telit Wireless Solutions WE866E4-P - Configure NHTTP Client Connection

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 118 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 250, page 118, describes the synchronous responses and remarks for Initiate NHTTP
Client Connection command.
9.5.2 Configure NHTTP Client Connection
This command is used to configure the HTTP Client Connection. Prior to issuing this
command L2 and L3 connection has to be established and HTTP client connection has to
be initiated.
Command Syntax AT+NHTTPCCFG=<CID>,<Configuration ID>,<Configuration
value1>,<Configuration value2>
Parameter Description
Table 251, page 118, describes the Configure NHTTP Client Connection parameters.
Response
Table 252, page 119, describes the responses and remarks for Configure NHTTP Client
Connection command.
Table 250 Initiate NHTTP Client Connection Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 251 Configure NHTTP Client Connection Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-16
Format: Integer
Default value: 0
It specifies the value given by issuing
AT+NHTTPCINIT command.
Configuration ID Mandatory
Value range:0-10
Format: Integer
Default value: 0
It specifies the list of available
configurations
Configuration
value1
Mandatory
Value
range:0-65535
Format: String
Default value: 0
It specifies the first configured value of the
configuration ID.
Configuration
value1
Mandatory
Value
range:0-65535
Format: String
Default value: 0
It specifies the second configured value of
the configuration ID.