Telit Wireless Solutions WE866E4-P - Safety and Usage Recommendations; Important Usage Precautions

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 49 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 74, page 49, describes the synchronous responses and remarks for Scanning
command.
7.1.3 Set MAC Address
This command is used to set the MAC address to the WLAN interface. Prior to issuing this
command the user required to initialize the WLAN interface.
Command Syntax AT+WMACS=<WHANDLE>,<MAC Address>
Parameter Description
Table 75, page 49, describes the Set MAC Address parameters.
Response
Table 76, page 50, describes the responses and remarks for Set MAC Address command.
Table 73 Scanning Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 74 Scanning Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 75 Set MAC Address Parameters
Parameters Mandatory/Optional Value Description
WHANDLE Mandatory
Value range: 0,1
Format: Integer
Default value: 1
It specifies the Device ID of the WLAN
interface, where
0- specifies disables WLAN interface
1- specifies enable the WLAN interface.
MAC
Address
Mandatory
Value range: 8
Format: Integer
Default value:
00:03:7f:56:04:74
It specifies the MAC address to be set for
the WLAN interface.