Telit Wireless Solutions WE866E4-P - Start SNTP

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 45 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 63, page 45, describes the synchronous responses and remarks for Get SNTP
Configuration command.
6.7.3 Start SNTP
This command is used to start the SNTP module. Prior to issuing this command, user is
required to establish L2 and L3 connection.
Command Syntax AT+NSNTPSTART
Response
Table 64, page 45, describes the responses and remarks for Start SNTP command.
Synchronous Response
Table 65, page 45, describes the synchronous responses and remarks for Start SNTP
command.
ERROR If parameter is not valid.
Table 62 Get SNTP Configuration Response
Responses Remarks
Table 63 Get SNTP Configuration Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 64 Start SNTP Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 65 Start SNTP Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.