Telit Wireless Solutions WE866E4-P - Close NHTTP Client Connection

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 120 2018-02-16
PRELIMINAR
Y
Response
Table 255, page 120, describes the responses and remarks for Send NHTTP Client
Connection command.
Synchronous Response
Table 256, page 120, describes the synchronous responses and remarks for Send NHTTP
Client Connection command.
9.5.4 Close NHTTP Client Connection
This command is used to close the HTTP Client Connection. Prior to issuing this command
L2 and L3 connection has to be established and HTTP client connection has to be initiated.
Command Syntax AT+NHTTPCCL=<CID>
Parameter Description
Table 257, page 120, describes the Close NHTTP Client Connection parameters.
Response
Table 258, page 121, describes the responses and remarks for Close NHTTP Client
Connection command.
Table 255 Send NHTTP Client Connect Connection Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 256 Send NHTTP Client Connection Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 257 Close NHTTP Client Connection Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-16
Format: Integer
Default value: 0
It specifies the value given by issuing
AT+NHTTPCINIT command.