Telit Wireless Solutions WE866E4-P - Service Discovery Using Nmdns; Start NMDNS Server

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 123 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 262, page 123, describes the synchronous responses and remarks for Network Ping
command.
10.1.2 Service Discovery using NmDNS
10.1.2.1 Start NMDNS Server
This command is used to start the server in mDNS module. Before issuing this command
is required to issue L2 and L3 commands.
Command Syntax AT+NMDNSSSTART
Parameter Description
Table 263, page 123, describes the Start NMDNS Server parameters.
Response
Table 264, page 124, describes the responses and remarks for Start NMDNS Server
command.
Table 261 Network Ping Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 262 Network Ping Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 263 Start NMDNS Server Parameters
Parameters Mandatory/Optional Value Description
Start Mandatory
Value range:N/A
Format: N/A
Default value:
N/A
It indicates the mDNS module to start.