Telit Wireless Solutions WE866E4-P - NMDNS Text Update

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 130 2018-02-16
PRELIMINAR
Y
10.1.2.8 NMDNS Text Update
This command is used to update a text record of the service in mDNS module.Prior to
issuing this command user is required to issue NMDNS start, set Host name and service
registration command.
Command Syntax AT+NMDNSUPDATETXT=<Service Name>,<Text Record>
Parameter Description
Table 283, page 130, describes the NMDNS Text Update parameters.
Response
Table 284, page 130, describes the responses and remarks for NMDNS Text Update
command.
Synchronous Response
Table 285, page 130, describes the synchronous responses and remarks for NMDNS Text
Update command.
Table 283 NMDNS Text Update Parameters
Parameters Mandatory/Optional Value Description
Service
Name
Mandatory
Value range:1-32
Format: String
Default value:
_QCA4020._MyD
evice._tcp.local
It specifies the service name of the service
to which the text record is to be updated.
Text Record Mandatory
Value range:1-32
Format: String
Default value:
Updated text
record
It specifies the text record of the service to
be updated.
Table 284 NMDNS Text Update Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 285 NMDNS Text Update Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.