WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 23 2018-02-16
PRELIMINAR
Y
6 General Operations
This chapter describes the commands for generic operations as required by Serial-to-WiFi
Application.
• Version, page 23
• Time Setting, page 23
• Profile Setting, page 26
• System Settings, page 29
• Heap Information, page 41
• System Reset, page 42
• SNTP Settings, page 43
6.1 Version
Content required
6.2 Time Setting
6.2.1 Set Time
This command is used to set and get the Julian time from RTC module.
Command Syntax AT+YTIME=<Absolute Time>
Parameter Description
Table 7, page 24, describes the Set Time parameters.
NOTE:
To Next Page
Loading...