Telit Wireless Solutions WE866E4-P - Page 22

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 22 2018-02-16
PRELIMINAR
Y
Response
Table 5, page 22, describes the responses and remarks for Configure UART command.
Synchronous Response
Table 6, page 22, describes the synchronous responses and remarks for Configure UART
command.
Example ATB=115200,3,0,1
OK
Table 4 Configure UART Parameters
Parameters Mandatory/Optional Value Description
BaudRate Mandatory
Value range:
110-921600
Format: Integer
Default value:
115200
It specifies the UART parameters
Bits per
Character
Optional
Value range: 0-3
Format: Integer
Default value: 3
It specifies the bits per character.
Parity Mode Optional
Value range: 0-3
Format: Integer
Default value: 0
It specifies the mode of the parity being
used.
Stop Bits Optional
Value range: 0-3
Format: Integer
Default value: 1
It specifies the number of stop bits.
Table 5 Configure UART Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 6 Configure UART Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.