Telit Wireless Solutions WE866E4-P - Get NDNS Server Start

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 71 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 125, page 71, describes the synchronous responses and remarks for NDNS Server
Start command.
8.2.2 Get NDNS Server Start
This command is used to get the status of the DNS server being started.
Command Syntax AT+NDNSSSTART?
Parameter Description
Table 126, page 71, describes the Get NDNS Server Start parameters.
Response
Table 127, page 71, describes the responses and remarks for Get NDNS Server Start
command.
Table 124 NDNS Server Start Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 125 NDNS Server Start Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 126 Get DNS Server Start Parameters
Parameters Mandatory/Optional Value Description
Status Mandatory
Value range: N/A
Format: String
Default value:
N/A
It indicates the status of the server
(STARTED or NOT STRARTED).
Table 127 Get NDNS Server Start Response
Responses Remarks
STARTED Success.