Telit Wireless Solutions WE866E4-P - Product Packaging

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 43 2018-02-16
PRELIMINAR
Y
6.7 SNTP Settings
6.7.1 SNTP Configuration
This command is used to configure the server in SNTP module. Prior to issuing this
command, user is required to issue SNTP start command.
Command Syntax AT+NSNTPCFG=<Server Address>,<Server ID>
Parameter Description
Table 58, page 43, describes the SNTP Configuration parameters.
Response
Table 59, page 43, describes the responses and remarks for SNTP Configuration command.
Synchronous Response
Table 60, page 44, describes the synchronous responses and remarks for SNTP
Configuration command.
Table 58 SNTP Configuration Parameters
Parameters Mandatory/Optional Value Description
Server
Address
Mandatory
Value range:1-32
Format: String
Default value:
pool.ntp.org
It specifies the server address to be
configured.
Server ID Optional
Value range:
0x0,0x1,0xFFFF
Format: Hexa
Default value:
FFFF
It specifies the ID of the server to be
configured.
Table 59 SNTP Configuration Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.