Telit Wireless Solutions WE866E4-P - NDNS Get Target Information

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 79 2018-02-16
PRELIMINAR
Y
Response
Table 148, page 79, describes the responses and remarks for NDNS Service Discovery
command.
Synchronous Response
Table 149, page 79, describes the synchronous responses and remarks for NDNS Service
Discovery command.
8.2.10 NDNS Get Target Information
This command is used to get target information in DNS module. Prior to issuing this
command the user is required to issue WNCN command.
Instance
Name
Mandatory
Value range:1-64
Format: String
Default value:
_Mydevice.tcp.loc
al
It specifies the name of the service to be
discovered.
IP Version Optional
Value range:
4,6,46
Format: Integer
Default value: 4
It specifies IP version to be used in service
discovery.
Time Out Optional
Value range:
0-5000
Format: Integer
Default value:
5000
It specifies the no activity time for
discovery request handling.
Table 147 DNS Service Discovery Parameters
Parameters Mandatory/Optional Value Description
Table 148 NDNS Service Discovery Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 149 NDNS Service Discovery Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.