WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 104 2018-02-16
PRELIMINAR
Y
9.3.1.10 SSL Listen
This command is used to listen to SSL socket. Prior to issuing this command, user is
required to establish L2 and L3 connection.
Command Syntax AT+NSSLL=<CID>,[<Backlog>]
Parameter Description
Table 215, page 104, describes the SSL Listen parameters.
Response
Table 216, page 104, describes the responses and remarks for SSL Listen command.
Synchronous Response
Table 217, page 104, describes the synchronous responses and remarks for SSL Listen
command.
9.3.1.11 SSL Read
This command is used to read SSL data from any of the Client device. Prior to issuing this
command, user is required to establish L2 and L3 connection.
Table 215 SSL Listen Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the value given by issuing
AT+NSSLINIT command.
Backlog Optional
Value range:1-15
Format: Integer
Default value: 0
It specifies the maximum length pending
connection in queue.
Table 216 SSL Listen Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 217 SSL Listen Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
To Next Page
Loading...