Telit Wireless Solutions WE866E4-P - Wireless; 7 Wireless Generic; Initialization

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 47 2018-02-16
PRELIMINAR
Y
7 Wireless
This chapter describes commands for configurations and operations related to WLAN layer
• Wireless Generic, page 47
• Wireless Network Connection Management, page 52
7.1 Wireless Generic
7.1.1 Initialization
This command is used to initialize WLAN interface.
Command Syntax AT+WI=<Mode>
Parameter Description
Table 69, page 47, describes the Initialization parameters.
Response
Table 70, page 47, describes the responses and remarks for Initialization command.
Synchronous Response
Table 71, page 48, describes the synchronous responses and remarks for Initialization
command.
Table 69 Initialization Parameters
Parameters Mandatory/Optional Value Description
Mode Mandatory
Value range: 0,1
Format: Integer
Default value: 0
It specifies the start of the WLAN
interface, taking following values:
0- specifies the interface starts in station
mode and
1- specifies the interface starts in AP
mode.
Table 70 Initialization Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.