Telit Wireless Solutions WE866E4-P - Get IP Configuration in AP Mode

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 56 2018-02-16
PRELIMINAR
Y
Response
Table 91, page 56, describes the responses and remarks for IP Configuration command.
Synchronous Response
Table 92, page 56, describes the synchronous responses and remarks for IP Configuration
command.
7.2.4 Get IP Configuration in AP mode
This command is used to get the IP configuration in AP mode.
Command Syntax AT+WNAPIPC?
Parameter Description
Table 93, page 57, describes the Get IP Configuration parameters.
Table 91 IP Configuration Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 92 IP Configuration Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.