Telit Wireless Solutions WE866E4-P - SSL Receive

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 105 2018-02-16
PRELIMINAR
Y
Command Syntax AT+NSSLRD=<CID>,[<Length of the data>]
Parameter Description
Table 218, page 105, describes the SSL Read parameters.
Response
Table 219, page 105, describes the responses and remarks for SSL Read command.
Synchronous Response
Table 220, page 105, describes the synchronous responses and remarks for SSL Read
command.
9.3.1.12 SSL Receive
This command is used to receive SSL data from any of the Client device. Prior to issuing
this command, SSL connection has to be established.
Command Syntax AT+NSSLRR=<CID>
Table 218 SSL Read Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the value given by issuing
command AT+SC (for UDP) or AT+SA
(for TCP).
Length of the data Mandatory
Value
range:1-1460
Format: Integer
Default value:
1460
Units: Bytes
It specifies the number of values to be
received.
Table 219 SSL Read Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 220 SSL Read Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.