Telit Wireless Solutions WE866E4-P - Receive MQTT Data

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 115 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 244, page 115, describes the synchronous responses and remarks for MQTT Receive
Request command.
9.4.7 Receive MQTT Data
This command is used to receive data. Prior to issuing this command, user is required to
establish MQTT connection.
Command Syntax AT+NMQTTR=<CID>,<Length of the Data>
Parameter Description
Table 245, page 115, describes the Receive MQTT Data parameters.
Response
Table 246, page 116, describes the responses and remarks for Recieve MQTT Data
command.
Table 243 MQTT Receive Request Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 244 MQTT Receive Request Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 245 Receive MQTT Data Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value:
N/A
It specifies the connection ID returned
during the MQTT connect command.
Length of the
Data
Mandatory
Value range:
0-1460
Format: Integer
Default value:
N/A
It specifies the length of the data to be
received.