Telit Wireless Solutions WE866E4-P - SSL Certificate Accept

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 97 2018-02-16
PRELIMINAR
Y
Response
Table 195, page 97, describes the responses and remarks for SSL Certificate Store
command.
Synchronous Response
Table 196, page 97, describes the synchronous responses and remarks for SSL Certificate
Store command.
9.3.1.4 SSL Certificate Accept
This command is used to accept Client connection and add it in the CID table. Prior to
issuing this command, user is required to establish L2 and L3 connection.
Table 194 SSL Certificate Store Parameters
Parameters Mandatory/Optional Value Description
Certificate Type Mandatory
Value range:0-3
Format: Integer
Default value: 0
It specifies the type of certificate,
0 - For CA certificate,
1- For client/server certificate.
Sequence Mandatory
Value range:1-10
Format: Integer
Default value: 0
It specifies the type of certificate,
0 - For CA certificate,
1- For client/server certificate.
Certificate Name Mandatory
Value range:0-50
Format: String
Default value: 0
It specifies the certificate name.
Certificate data Mandatory
Value
range:1-6400
Format: Binary
Default value: 0
It specifies the certificate data to be stored.
Table 195 SSL Certificate Store Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 196 SSL Certificate Store Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.