Telit Wireless Solutions WE866E4-P - SSL Send

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 106 2018-02-16
PRELIMINAR
Y
Parameter Description
Table 221, page 106, describes the SSL Receive parameters.
Response
Table 222, page 106, describes the responses and remarks for SSL Receive command.
Synchronous Response
Table 223, page 106, describes the synchronous responses and remarks for SSL Receive
command.
9.3.1.13 SSL Send
This command is used to send data to SSL connection. Prior to issuing this command, SSL
connection has to be established.
Command Syntax AT+NSSLWR=<CID>,[<Destination IP Address>,<Destination port
number>,<Data>]
Parameter Description
Table 224, page 107, describes the SSL Send parameters.
Table 221 SSL Receive Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the value given by issuing
command AT+NSSLINIT.
Table 222 SSL Receive Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 223 SSL Receive Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.