Telit Wireless Solutions WE866E4-P - Page 107

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 107 2018-02-16
PRELIMINAR
Y
Response
Table 225, page 107, describes the responses and remarks for SSL Send command.
Synchronous Response
Table 226, page 107, describes the synchronous responses and remarks for SSL Send
command.
Table 224 SSL Send Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the value given by issuing
command AT+NSSLINIT.
Destination IP Address Optional
Value range:7-40
Format: Integer
Default value:
0.0.0.0
It specifies the destination IP address to
send the data
Destination port number Optional
Value
range:1-1460
Format: Integer
Default value: 0
It specifies the port number of the
destination IP address to sent the data.
Data Optional
Value
range:0-65535
Format: Binary
Default value:
Welcome to Telit
It specifies the data to be sent.
Table 225 SSL Send Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 226 SSL Send Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.