Telit Wireless Solutions WE866E4-P - NDNS Server Stop

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 72 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 128, page 72, describes the synchronous responses and remarks for Get NDNS
Server Start command.
8.2.3 NDNS Server Stop
This command is used to get the status of the server being stopped.
Command Syntax AT+NDNSSSTOP?
Parameter Description
Table 129, page 72, describes the Get NDNS Server Stop parameters.
Response
Table 130, page 72, describes the responses and remarks for Get NDNS Server Stop
command.
NOT STARTED Unsuccessful.
Table 127 Get NDNS Server Start Response
Responses Remarks
Table 128 Get NDNS Server Start Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 129 Get DNS Server Stop Parameters
Parameters Mandatory/Optional Value Description
Status Mandatory
Value range: N/A
Format: String
Default value:
N/A
It indicates the status of server (STOPPED
or RUNNING).
Table 130 Get NDNS Server Stop Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.