Telit Wireless Solutions WE866E4-P - Page 101

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 101 2018-02-16
PRELIMINAR
Y
Response
Table 207, page 101, describes the responses and remarks for Configure SSL command.
Synchronous Response
Table 208, page 101, describes the synchronous responses and remarks for Configure SSL
command.
Table 206 Configure SSL Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the connection ID after
AT+NSSLINIT command.
Configuration ID Mandatory
Value range:0-20
Format: Integer
Default value: 0
0: Invalid configuration parameter,
1: To set SSL certificate,
2: To Set SSL CA Certificate,
3: To set Cipher information,
4: To enable/disable Time validation,
5: To enable/disable SSL alert,
6: To set the domain,
7: To et the maximum fragment length,
8: To set negotiation,
9: To set the SNI,
10: To set the ALPN extension.
Configuration value Mandatory
Value range:1-64
Format: String
Default value: 0
It specifies value of the configuration ID.
Table 207 Configure SSL Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 208 Configure SSL Synchronous Response
Responses Remarks
OK Success.
FAILURE If starting the server is unsuccessful.