©Tormach® 2023
Specifications subject to change without notice.
Page 12 Tormach 1100M® Operator's Manual (Version 1223A)
For the most recent version, see tormach.com/support
Automatic E-Stop Loop Recording ("Dashcam") 149
Review Video and Image Files 149
File Naming Convention 150
G-Code Commands 150
File Naming Conventions 150
Use M01 to Take Pictures 150
7.3 Set Up G-Code Programs 151
7.3.1 Use a Probe with PathPilot 151
Set Up the Probe 151
Use a Probe to Find a Feature's Location 151
Use a Probe to Set Work Offset Zeroes 151
Set the X and Y Work Offset Zero on the Corner of a Feature 151
Set the Work Offset Zeroes on a Feature 151
Use a Probe to Find the Center of a Feature 152
Find the Center of a Pocket 152
Find the Center of a Slot 152
Find the Center of a Rectangular Boss 152
Find the Center of a Circular Boss 152
Find the Center Rotation of an A-Axis 153
7.3.2 Set Tool Length Offsets 153
About Tool Offsets 153
Touch Off the Tool Length Offsets 154
Set a Known Reference Height 154
Measure Tools Using a Known Reference Height 154
Use an ElectronicTool Setter (ETS) to Measure Tools 155
Use a Height Gauge to Measure Tools 155
7.3.3 Set Work Offsets 156
About Work Offsets 156
7.3.4 View Work Offsets 156
7.3.5 View Available G-Code Modes 157
7.4 Run G-Code Programs 157
7.4.1 Bring the Machine Out of Reset 157
About Reset Mode 157
7.4.2 View the Active Axis to Jog 157
7.4.3 Jog the Machine 157
Jog in Continuous Velocity Mode 158
Jog in Step Mode 158
7.4.4 View the Current Machine Position 158
7.4.5 Reference the Machine 158
About Referencing 159
7.4.6 Start a Program 159
About Cycle Start 159
Cycle Start Reference 159
7.4.7 Stop Machine Motion 159
7.4.8 Operate the Coolant Pump 159
TABLE OF CONTENTS
To Next Page
