©Tormach® 2023
Specifications subject to change without notice.
Page 16 Tormach 1100M® Operator's Manual (Version 1223A)
For the most recent version, see tormach.com/support
Arc in XY Plane 201
Arc in XZ Plane 201
Arc in YZ Plane 201
10.2.5 Dwell (G04) 202
10.2.6 Set Offsets (G10) 202
Set Tool Table (G10 L1) 202
Set Coordinate System (G10 L2) 203
Set Tool Table (G10 L10) 203
Set Tool Table (G10 L11) 203
Set Coordinate System (G10 L20) 203
10.2.7 Plane Selection (G17, G18, G19) 204
10.2.8 Length Units (G20 and G21) 204
10.2.9 Return to Predefined Position (G28 and G28.1) 204
10.2.10 Return to Predefined Position (G30 and G30.1) 204
10.2.11 Automatically Measure Tool Lengths with an ETS (G37 and G37.1) 204
Move to G37 Position Over ETS (G37.1) 204
Move and Measure Tool Length (G37) 205
10.2.12 Straight Probe (G38.x) 205
Use the Straight Probe Command 206
10.2.13 Cutter Compensation (G40, G41, G42) 206
10.2.14 Dynamic Cutter Compensation (G41.1 and G42.1) 207
10.2.15 Apply Tool Length Offset (G43) 207
10.2.16 Engrave Sequential Serial Number (G47) 207
10.2.17 Cancel Tool Length Compensation (G49) 208
10.2.18 Absolute Coordinates (G53) 208
10.2.19 Select Work Offset Coordinate System (G54 to G54.1 P500) 208
10.2.20 Set Exact Path Control Mode (G61) 208
10.2.21 Set Blended Path Control Mode (G64) 208
10.2.22 Distance Mode (G90 and G91) 208
10.2.23 Arc Distance Mode (G90.1 and G91.1) 209
10.2.24 Temporary Work Offsets (G92, G92.1, G92.2, and G92.3) 209
10.2.25 Feed Rate Mode (G93, G94, and G95) 209
10.2.26 Spindle Control Mode (G96 and G97) 210
10.3 Programming Canned Cycles 210
10.3.1 Canned Cycles Reference 210
Supported Canned Cycles 210
10.3.2 High Speed Peck Drill (G73) 211
10.3.3 Cancel Canned Cycles (G80) 212
10.3.4 Drilling Cycle (G81) 212
10.3.5 Simple Drilling Cycle (G82) 213
10.3.6 Peck Drilling Cycle (G83) 213
10.3.7 Tapping Cycle (G84) 213
10.3.8 Boring Cycle (G85) 213
10.3.9 Boring Cycle (G86) 214
10.3.10 Boring Cycle (G88) 214
TABLE OF CONTENTS
To Next Page
