Tormach 1100M - Page 17

©Tormach® 2023
Specifications subject to change without notice.
Page 17 Tormach 1100M® Operator's Manual (Version 1223A)
For the most recent version, see tormach.com/support
TABLE OF CONTENTS
10.3.11 Boring Cycle (G89) 214
10.4 Programming M-Code 214
10.4.1 Supported M-Codes Reference 214
10.4.2 Program Stop and Program End (M00, M01, M02, and M30) 215
Display Information and Capture Images During an M00 or M01 Break 215
Display Information with Images 215
Display Information with Text 215
Capture Images with a USBCamera 216
10.4.3 Spindle Control (M03, M04, and M05) 216
10.4.4 Tool Change (M06) 216
10.4.5 Coolant Control (M07, M08, and M09) 216
10.4.6 Override Control (M48 and M49) 216
10.4.7 Feed Override Control (M50) 216
10.4.8 Spindle Speed Override Control (M51) 216
10.4.9 Set Current Tool Number (M61) 217
10.4.10 Set Output State (M64 and M65) 217
10.4.11 Wait on Input (M66) 217
10.4.12 USB Camera Control (M301, M302, M303) 217
10.5 Programming Input Codes 218
10.5.1 Feed Rate (F) 218
10.5.2 Spindle Speed (S) 218
10.5.3 Change Tool Number (T) 218
10.6 Advanced Programming 218
10.6.1 Parameters 218
Parameters Reference 218
Parameter Syntax 218
Parameter Scope 219
Behavior of Uninitialized Parameters 219
Parameter Mode 219
Persistence and Volatility 219
Intended Use 219
Numbered Parameters Reference 219
Read-Only Parameters 219
Subroutine Parameters Reference 220
Named Parameters Reference 220
10.6.2 Expressions 220
Binary Operators Reference 220
Functions Reference 221
10.6.3 Subroutines 221
Subroutines Reference 221
Conditional Subroutines Reference 222
if/endif 222
if/elseif/else/endif 222
Repeating Subroutines Reference 223
Looping Subroutines Reference 223