©Tormach® 2023
Specifications subject to change without notice.
Page 18 Tormach 1100M® Operator's Manual (Version 1223A)
For the most recent version, see tormach.com/support
do/while 223
while/endwhile 223
MACHINE MAINTENANCE
225
11.1 Maintenance Safety 226
11.1.1 All Maintenance Procedures 226
11.1.2 Swarf Maintenance Procedures 226
11.1.3 Coolant Maintenance Procedures 226
11.2 Maintenance Schedules 226
11.2.1 Daily 226
11.2.2 Weekly 226
11.2.3 Monthly 226
11.2.4 Semi-Annually 226
11.2.5 Annually 227
11.3 Regular Maintenance 227
11.3.1 Clean the Way Covers 227
11.3.2 Clean the Coolant System 227
About Cutting Fluid 227
Cutting Fluid Reference 227
11.3.3 Examine the Drawbar 228
11.3.4 Examine the Enclosure Windows 228
11.3.5 Lubricate the Machine 228
About the Manual Oiler 228
About the Automatic Oiler 229
Lubrication System Reference 229
11.3.6 Examine the Spindle Belt 229
11.3.7 Examine the Tormach Tooling System (TTS) Collet 229
11.3.8 Prevent Rust 229
Remove Rust 229
TROUBLESHOOTING
231
12.1 Troubleshooting Safety 232
12.2 Getting Help 232
12.3 Required Tools 232
12.4 Frequently Found Problems 233
12.5 Electrical Service 234
12.6 Power Distribution Subsystem 234
12.6.1 The Controller Won't Power On 234
12.6.2 The Coolant Pump Won't Run 235
12.7 Control Power Subsystem 236
12.7.1 The Machine Won't Power On 236
12.8 Axes Drive Subsystem 237
12.8.1 All Axes Won't Move When Commanded 238
12.8.2 One Axis Won't Move (or Only Moves in One Direction), and Other Axes Move 238
Motor Resistance Reference 241
TABLE OF CONTENTS
To Next Page
