TR-Electronic MP Series - Table 3: Parameter Identification (PKE); Table 4: PKW Error Numbers

Printed in the Federal Republic of Germany  TR-Electronic GmbH 2008, All Rights Reserved
06/06/2019 TR - EMO - BA - DGB - 0019 - 08 Page 157 of 252
The PKE range is used to identify parameters and the type of access:
Bit
Significance
15-12
Order identification: Control => encoTRive
response identification: encoTRive => Control
0 : no order
1 : Request parameter value
2 : Change parameter value (word)
3 : Change parameter value (double word)
4 : Request parameter description
5 : -
6 : Request parameter value (array)
7 : Change parameter value (array word)
8 : Change parameter value (array double word)
9 : Request number of array elements
0 : no response
1 : Transmit parameter value (word)
2 : Transmit parameter value (double word)
3 : Transmit parameter description
4 : Transmit parameter value (array word)
5 : Transmit parameter value (array double word)
6 : Transmit number of array elements
7 : Order cannot be executed
11
reserved
10-0
Parameter number (PNU)
Table 3: Parameter identification (PKE)
If the value 7 is given as the response identification (“Order cannot be executed”),
then the PWE range is assigned an error number, which specifies the cause of the
fault. These are shown in the following table:
Error number
Significance
0x0000
Invalid PNU
0x0001
Value cannot be changed
0x0002
Value range exceeded
0x0003
Invalid subindex
0x0004
Parameter is not an array
0x0005
Wrong data type
0x0006
Setting not allowed
0x0007
Description element cannot be changed
0x0009
Description data not available
0x000B
No control priority
0x000C
Wrong password
0x0011
Wrong operating state
0x0012
Other fault
0x0014
Invalid value
0x0015
Reply too long
0x0016
Address range inadmissible
0x0017
Invalid format
0x0018
Number of values inconsistent
Table 4: PKW error numbers