TR-Electronic MP Series - Description of Parameters; Table 26: Description of Parameters

The object directory
 TR-Electronic GmbH 2008, All Rights Reserved Printed in the Federal Republic of Germany
Page 196 of 252 TR - EMO - BA - DGB - 0019 - 08 06/06/2019
8.3 Description of parameters
Each parameter in the encoTRive object directory has a parameter description,
which contains information relating to the parameter. The parameter description is
stored in the encoTRive memory and can be read out by means of the PKW or acyclic
reading order.
The parameter description for a parameter has a fixed length of 46 bytes.
The individual elements of the parameter description can be accessed by means of
the subindex. If subindex 0 is used, then this means the whole of the parameter
description.
Subindex
Significance
Meaning
0
Full description (46 bytes)
Content of sub indices 1-12
1
Identifier (2 bytes)
bit
significance
15
reserved
14
1-Array 0-Simple parameter
13
1-Parameter can only be reset (e.g.
time difference)
12
1-Parameter has been changed from
the factory setting
11
reserved
10
1-Additional text array available
9
1-Parameter cannot be written
8
1-Normalization and size attribute not
relevant
0-7
Data type (cf. Table 25)
encoTRive uses only bits
0-7, 9, 14.
The following values are fixed for
the remaining bits:
bit 13: 0
bit 12: 0
bit 10: 0
bit 8: 0
2
Number of array elements or string length (2 bytes)
If the parameter is an array parameter, then the
number of array elements is specified here.
In the case of a character string, this element
contains the length of the string.
3
Normalization factor (4 bytes)
Floating-point number with which an internal value
can be converted to a physical representation.
Not used for encoTRive.
4
Attribute (2 bytes)
Physical unit / quantity
Not used for encoTRive.
5
Reserved (4 Byte)
6
Name (16 Byte)
Parameter name. Character string
7
Lower limit value (4 Byte)
8
Upper limit value (4 Byte)
9
Reserved (2 Byte)
10
ID extension. Reserved (2 Byte)
Not used for encoTRive.
11
PZD reference parameter (2 bytes)
Not used for encoTRive.
12
PZD normalization (2 bytes)
Not used for encoTRive.
Table 26: Description of parameters